Dimensions

BARRY-BOND MOUNT SERIES SNUBBING WASHER

The use of snubbing washers is recommended to ensure proper static and dynamic loading of the isolator and retention of suspended equipment under severe shock environments

Snubbing washers are ordered by separate part numbers as shown in the table below. The standard material is low-carbon steel and the standard finish is zinc plate. Other materials and finishes are available upon request.

Part # Head Washer
Part #
Part Dimensions(inches) Tail Washer
Part #
Part Dimensions
A B C A B C
BC-1120-1 9810276-02804 1.25 0.40 0.125 9810276-01804 1.12 0.40 0.125
BC-1120-3 9810276-02804 1.25 0.40 0.125 9810276-01804 1.12 0.40 0.125
BC-1121-2 9810276-04804 2.00 0.52 0.125 9810276-03804 1.50 0.52 0.125
BC-1121-4 9810276-04804 2.00 0.52 0.125 9810276-03804 1.50 0.52 0.125
BC-1122-2 9810276-05804 2.25 0.52 0.125 9810276-04804 2.00 0.52 0.125
BC-1122-4 9810276-05804 2.25 0.52 0.125 9810276-04804 2.00 0.52 0.125
BC-1123-2 9810276-08804 2.88 0.66 0.125 9810276-06804 2.25 0.64 0.125
BC-1123-5 9810276-08804 2.88 0.66 0.125 9810276-06804 2.25 0.64 0.125
BC-1124-2 9810276-10804 3.50 0.64 0.190 9810276-07804 2.50 0.64 0.125
BC-1124-5 9810276-10804 3.50 0.64 0.190 9810276-07804 2.50 0.64 0.125
BC-1125-2 9810276-11804 4.25 0.80 0.190 9810276-09804 3.00 0.80 0.190
BC-1125-4 9810276-11804 4.25 0.80 0.190 9810276-09804 3.00 0.80 0.190